Storage at high temperatures or high humidity may reduce shelf life. Place unused epoxy putty in polythene bags and re-seal. Milliput will have a storage life of approximately 2 years providing it is stored in cool, dry conditions. Milliput products are resistant to frost, heat, solvents and most fuels. When casting or mouldmaking talc or a light oil can be used as a releasing agent. If the hands have been used for mixing or manipulating Milliput wash them immediately after use with toilet soap and warm water. When rubber gloves have been used wash them immediately after use, and whilst still on the hands, using running water. When mixing the two components it is advisable to use rubber gloves or throw-away polythene gloves. In the putty state Milliput, like most chemicals in domestic use, may cause irritation to sensitive skins. If the putty is allowed to harden on it will be almost impossible to remove. When tools have been used for applying or contouring Milliput they should be cleaned immediately after use. To obtain a smooth finish, mould or apply Milliput and then immediately wipe and smooth gently with wet finger or with a fine textured moist cloth. There are certain instances when work may be carried out in a gentle stream of water under a tap. To aid manipulation and avoid sticking, fingers and tools should be kept moistened with water. the putty may now be applied and will set hard in three to four hours without shrinking.Īt all stages from initial mixing to final setting Milliput responds to the use of water. Abrading the surface will improve adhesion. Smooth surfaces should be cleaned with a suitable solvent or with soap and warm water to remove dirt and grease. The surfaces to which the putty is applied should be free from grease and dirt. Knead and roll in the hands for at least 5 minutes until the colours merge and become uniform and no streaks can be seen, and then mix for another minute. Mix together equal parts of each stick from the pack. Milliput will set under water and is heat resistant up to 130*C. Milliput is an excellent adhesive and will bond any of the following to itself or to any of the others - wood, brick, cement, metals, concrete, plastics, glass etc, but note that Milliput is not intended as a thin layer adhesive. Once fully cured Milliput can be machined, drilled, tapped, turned, filed, sawn, sandpapered and painted. By the application of heat the setting time can be reduced.Īfter setting hard Milliput continues to cure and is fully cured after an elapse of time equal to the setting time at the same temperature. Speed of hardening is dependant on temperature and at normal temperatures (20-25 deg C) Milliput becomes rock hard in three to four hours. Once equal quantities of each stick have been mixed the resultant putty is at first soft and highly adhesive and then gradually hardens. sticks and the general instructions for preparation and usage are the same. Each grade is presented in similar packs containing 2 x 56*7gm. Success with that one has spurred me on to repair another more visible trim panel and having learned a couple of techniques from the first one has given me a much improved repair.Milliput produces five grades of epoxy putty: Standard (Yellow/Grey), Terracotta, Silver Grey, Black and Superfine White. Maybe not a perfect repa ir (due to my skills, rather than the product) but is strong enough to hold quite a heavy trim panel. Gave me a nice smooth finish, the panel was black and so was the Milliput i bought so all i needed to do was tidy up with a file, emery tape and drill the holes. Cut two equal lengths of the putty and hardener, mixed and massaged them together just like Plasticine then pushed and pulled and tweaked them into shape in the holes, using a wetted (with water) coffee-stirring stick from a well-known, Scottish sounding American burger chain. Forgot about it for the best part of the 30 years in between but was reminded of it on a car forum recently.īought some as an experiment to see if it would do what i needed - repairing a trim panel around the mounting holes which had disintegrated with age. First used this product about 35 years ago at work and was impressed then.
0 Comments
Leave a Reply. |